Best Stud Finder

Best Stud Finder

When you are going to redesign your restroom, it might involve extensive labor. The wall and the flooring tiles in your restroom can add a practically impenetrable layer of the moisture protection which you may not wish to remove. Although it is possible for you to straight paint on the surface area of your tiles with appropriate preparation, you will still be able to see the grout lines and recognize that it is painted tile. The right way to cover your restroom tiles is basically to install a thin layer of the drywall over the tiles and then protect it to the walls with adhesive and screws. Simply follow some instructions below to quickly cove your bathroom tiles.

The first step is to hold the best stud finder versus the wall. After that, you should press the “Locator” button on the side of the best stud finder and then move it gradually throughout the wall. You have to make a pencil mark on the wall every time the sign light on the best stud finder illuminates and also whenever it goes off.

The 2nd action is to hold the level versus each line. In this action, you need to change the level so that it can completely plump at each pencil mark. You need to draw the line down the side of the level at each mark in order to reveal the edges of every stud in the wall. Then, you can continue these lines 2 inches on to the floor and the ceiling so that you can discover them when the drywall is set up.

The 3rd action is to position the line of the building and construction adhesive 2 inches from each edge of each piece of the drywall. You need to position a series of lines of the adhesive 4 inches across the back of each piece of the drywall. After that, you need to push the drywall versus the tile wall. You have to make completion of every board end between a set of the stud marks.

Best Stud Finder

The 4th step is to cut the drywall as required by using a razor knife and then put a row of the drywall horizontally along the bottom half of the wall. You must put the horizontal row of the drywall throughout the leading part of the wall. Likewise, you have to develop the breaks between the boards in the top row break in the middle of the boards below.

Last but not least, you need to apply substance to every screw head in the wall by using drywall knife. Exactly what you need to apply is a 1/4-inch layer of the mud over each screw and also scrapes off the excess mud by using the blade of the knife. Then, You should apply a 1/4-inch layer of the substance over each joint in the wall. You need to push the drywall tape into the mud in order to cover each seam. Cut the tape using the corner of the blade of your knife. You need to hold the end of the piece of the tape as well as drag the flat of the blade along the length of the tape for pushing it into the substance and pull the excess mud off the wall.

Click https://www.digperformance.com to read more infomation about best stud finder.